Teflex Anti-Mould is designed to kill mould and to prevent recurrence of mould, algae and other micro-organisms on wood, concrete, brick and any other absorbing surface.
It may be used in all premises with high humidity (bathrooms, cellars, utility rooms, saunas, etc), in industrial buildings, children’s play areas, and anywhere that can benefit from safe disinfection.

It is recommended to apply Teflex Anti-mould at all stages of construction and property repair. It may also be added to cement, mortar, plaster and water soluble paints.
It has good adhesion properties and weather resistance and can be painted over with water soluble paint.

Teflex Anti-mould comes in containers: 1l, 3l, 5l, 10l and 200l
Type: A water-based antiseptic concentrate, building disinfectant.

Purpose
Teflex Anti-mould can be applied to protect and treat wood, concrete, brick and surfaces with good absorbing ability.

Properties
Excellent protection against bio-contamination. Good weather resistance. Easy to use. Good adhesion to all surfaces. Long-lasting effect of disinfection. Works well with water soluble paints. Can be mixed with cement, mortar and plaster – building in protection and acting as a plasticiser.
Structure: Antiseptics – a complex of guanidine copolymers. Solvent=water. pH is 7 (neutral).
Density: 1.1 g/cubic centimetre
Packaging: 0.33l, 1l, 3l, 5l, 200l
Colour: Transparent, yellowish
Safety precautions: Keep away from children. Do not inhale. Avoid contact with eyes and skin. More detailed information can be found on the MSDS sheet.
Storage: The bottle should be kept airtight.
Period of storage = no more than 3 years.
Waste: Treat as household waste.

Teflex Anti-mould Application Instructions
Substrates: Wood, concrete, rick and plastered surfaces should be clean and have good absorbing ability.
Preparation of substrates:
New wood- sand in direction of grain and ensure removal of any surface deposits.
Old wood- sand off any dead surface material until healthy wood is exposed.
Brick/concrete- clean with a wire brush and then dry with gas torch or hot air blower.
Apply Teflex Anti-mould by spraying or brushing.
Use dilution rates as recommended by manufacturer (1 Teflex : 9 water).
For disinfection of air use dilution rate 1 Teflex : 99 water).

Application: 150ml per square metre dependent on surface of application. Optimal protection gained at 250ml per square metre.
Temperature: Air and surface temperature should be not below 5 degrees Celsius. Preferable temperature is 15-25 degrees Celsius.
Drying: at 20 degrees. Partial drying occurs at 45 minutes for the first layer. Apply 2nd layer after 3 hours and a third at 5 hours.
Waste: Treat as household waste.
Consultations: We can answer any questions regarding this technology and would advise you to contact us.